.jpg)
- Tissue
- 肝脏
- Disease
- 肝细胞癌
- Synonyms
- AH130FN-TC, AH130FN, AH-130F(N), AH-130FN, AH 130 FN
Documents
AH-130 FN
Cell line · Product number 500451
AH-130 FN is a variant of the AH-130 rat ascites tumor cell line, used extensively in studies related to coagulation, fibrinolysis, and metastasis. These ...
Recommended (freshest lot)
01General information
- Description
AH-130 FN 是 AH-130 大鼠腹水瘤细胞系的变种,广泛用于凝血、纤溶和转移相关研究。这些细胞来源于大鼠,通常通过连续腹腔植入雄性唐柳大鼠来维持。AH-130 细胞系本身以其高度的血栓形成活性和纤维蛋白溶解活性而闻名,这与其在促进血液转移(尤其是肺部转移)方面的作用有关。相比之下,AH-130 FN 变体的血栓形成活性和纤维蛋白溶解活性较低。AH-130 和 AH-130 FN 在酶活性上的这种差异至关重要,因为它影响着静脉注射后血栓的形成和肺部转移灶的数量。
研究表明,静脉注射后,AH-130 细胞会导致血小板数量和纤维蛋白原水平显著下降,表明血栓形成增加。与 AH-130 FN 相比,这种效果更为明显。组织学研究表明,与 AH-130 FN 相比,AH-130 在接种后 72 小时和 7 天内在肺部形成的转移灶更多。AH-130 与栓塞肿瘤细胞周围由血小板和纤维蛋白组成的血栓形成有关,而 AH-130 FN 则显示血栓形成稀少。这些发现表明,AH-130 较高的血栓形成活性在通过血小板聚集和纤维蛋白沉积在肿瘤细胞周围促进转移方面发挥了重要作用,而 AH-130 FN 的这一过程则不那么突出。
- Tissue
- 肝脏
- Disease
- 肝细胞癌
- Synonyms
- AH130FN-TC
- AH130FN
- AH-130F(N)
- AH-130FN
- AH 130 FN
02Classification
- Organism
- Rat
- Growth properties
- Adherent and suspension
- Biosafety level
- 1
03Characteristics
- Morphology
- 悬浮液中的圆形细胞,粘附时呈上皮样
- Tumourigenic
- 是的,在 Wistar 大鼠身上。
04Identifiers
- Citation
- AH-130 FN(Cytion 目录号 500451)
- NCBI TaxID
- 10116
- Cellosaurus
- CVCL_5683
05Expression and susceptibility
- Viruses
- RAP 测试阴性。.
06Handling and culture
- Culture medium
- DMEM:Ham's F12(1:1),w: 3.1 g/L 葡萄糖,w: 2.5 mM L-谷氨酰胺,w: 15 mM HEPES,w: 0.5 mM 丙酮酸钠,w: 1.2 g/L NaHCO3(Cytion 文章编号 820400a)。
- Incubation atmosphere
37°C, 5%CO2, 加湿环境。
- Supplements
- 在培养基中添加 10% FBS
- Subculturing
- 通过上下吸取操作轻柔匀化烧瓶中的细胞悬液,随后取代表性样本测定每毫升细胞密度。用新鲜培养基将悬液稀释至1×10⁵细胞/毫升浓度,并将调整后的悬液分装至新烧瓶中进行后续培养。
- Seeding density
- 1 × 10⁶ 个细胞/平方厘米
- Fluid renewal
- 每 3 至 5 天
- Post-thaw recovery
- 解冻后,将细胞以5×10⁴个细胞/平方厘米的密度接种于培养皿中,使细胞从冷冻过程中恢复并至少贴壁24小时。
- Thawing and culturing
Confirm that the vial remains deeply frozen upon delivery, as cells are shipped on dry ice to maintain optimal temperatures during transit.
Upon receipt, either store the cryovial immediately at temperatures below -150°C to ensure the preservation of cellular integrity, or proceed to step 3 if immediate culturing is required.
For immediate culturing, swiftly thaw the vial by immersing it in a 37°C water bath with clean water and an antimicrobial agent, agitating gently for 40-60 seconds until a small ice clump remains.
Perform all subsequent steps under sterile conditions in a flow hood, disinfecting the cryovial with 70% ethanol before opening.
Carefully open the disinfected vial and transfer the cell suspension into a 15 ml centrifuge tube containing 8 ml of room-temperature culture medium, mixing gently.
Centrifuge the mixture at 300 x g for 3 minutes to separate the cells and carefully discard the supernatant containing residual freezing medium.
Gently resuspend the cell pellet in 10 ml of fresh culture medium. For adherent cells, divide the suspension between two T25 culture flasks; for suspension cultures, transfer all the medium into one T25 flask to promote effective cell interaction and growth.
Adhere to established subculture protocols for continued growth and maintenance of the cell line, ensuring reliable experimental outcomes.
07Quality control and cryopreservation
- Sterility
使用基于 PCR 的检测方法和基于发光的支原体检测方法排除支原体污染。
为确保没有细菌、真菌或酵母菌污染,每天都要对细胞培养物进行目视检查。
- Freeze medium
- 我们使用完全生长培养基(包括 FBS)+10% DMSO 或 CM-1(Cytion 商品目录编号 800100)作为冷冻保存培养基,以获得足够的解冻后存活率,CM-1(Cytion 商品目录编号 800100)含有优化的渗透保护剂和代谢稳定剂,可提高恢复能力并减少冷冻引起的应激。
- Storage conditions
如需长期保存,可将样品瓶放入气相液氮中,温度约为 -150 至 -196 ℃。在-80 °C下保存只能作为转入液氮前的短暂过渡。
- Shipping conditions
冷冻保存的细胞系用干冰装运,并用经过验证的隔热包装和足够的制冷剂在整个运输过程中保持约 -78 °C 的温度。收到货后,应立即检查容器,并立即将小瓶转移到适当的储藏室。
08Legal and safety
- Safety precautions
- 计划将低温样品储存在液氮中以便将来解冻时,必须遵守严格的安全措施。在将冷冻样本移入或移出液氮罐时,必须穿戴适当的防护手套和防护服,并使用面罩或安全护目镜。这样做是为了降低在移出时因冷冻样品爆炸而造成伤害的风险,因为爆炸可能导致锋利的碎片飞溅。
- Disclaimer
- 我们提供的细胞仅用于体外实验室研究目的,不用于临床或诊断用途,也不得用于人类或兽医目的。用户必须遵守在研究环境中处理和使用这些细胞的所有适用准则和法规。
- Warranty
在Cytion,我们保证产品的质量和活力。 我们保证,从我们的工厂发货后 60 天内,我们的细胞在开始培养时都是存活的。 我们保证所有材料均符合分析证书和/或产品说明书中描述的规格。
有关详细信息,请参阅我们的 <a href="" /Who-we-are/Warranty/"" hreflang=""x-default"">保修声明 。
- Material Transfer Agreement required
- Yes